Peak
Ozone™ | Northern Lights™
| Therapy Air | AquaTremor™
| Cover Lifter | Cedar

Ozone is perhaps nature's most powerful purifier. It is widely used
to purify drinking water because it is pH neutral, chelates metals and
destroys pathogens and other organic contaminants quickly and with no
residual chemicals remaining in the water. Despite ozone's (O3) great
potency, nearly all systems on spas utilize designs that fail to address
the three critical components needed for successful water purification.
These components are:
Concentration of Ozone: You must produce
enough ozone at high concentration to purify and you must do so year
after year without significant change in ozone output.
Contact Time: The Ozone must come in contact
with the contaminants and have long enough time period to create a reaction.
Off-Gas Destruction: Any ozone that has
not reacted must be converted back to oxygen to prevent unwanted oxidation.
Length of Ozone System Operation: The Peak
Ozone System operates 24 hours a day. Delivering purifying ozone to
the spa constantly. Most spas ozone systems only operate during filtration,
which is a fraction of that time.
The Peak Ozone System™ is the only
system used on portable spas that successfully accomplishes the above.
Here's how...
We begin with a Cold Fusion Corona Discharge
Ozone Generator that is certified to produce 0.5 g/hr of ozone at a
high concentration flow rate of 1.25 - 2 l/min. To ensure we have as
much of the ozone mixed into solution as possible, we force it through
a patented Mazzei™ Injector. This pushes the ozone into a vacuum
where the molecules are shattered into fragments smaller than water
particles. Approximately 99 percent of the ozone will be mixed into
solution as a result of this process.
Next, the ozone is kept in solution for
a minimum contact time of 18 seconds to allow it to oxidize organic
contaminates from the impure spa water. This is done by forcing the
water through our Static Mixing Chamber. This special chamber utilizes
the latest in mixing technology within the Tri-Pac Reaction Zone. The
goal here is to increase contact time by slowing down the water flow,
further mixing the ozone and facilitating a reaction.
A very small percentage of ozone gas will
remain out of solution and this we need to isolate and neutralize. The
Peak's Off-Gas Chamber accomplishes this by allowing undissolved ozone
to rise naturally to the top of this chamber, where it is pulled through
the Off-Gas Destruct Filter. This catalytic filter converts the ozone
back to pure oxygen.
Finally, the ozone in solution is injected
into the vacuum of the Floating-Weir Filter and from there travels to
the spa's manifolds and jetting system until it is re-introduced into
the spa as pure water.
The science behind the Peak Ozone System™
may seem complex, but the results are amazing and the maintenance for
you, the spa owner, is virtually non-existent. For Peak performance
in water maintenance, choose the Peak Ozone System™, available
only with Arctic Spas®.